Description
XPARTCO 6501KW2001A Washer Rotor Positioning Sensor – Compatible with LG and Kenmore Washers
Product Description
Restore accurate motor control and spin performance with the XPARTCO 6501KW2001A Washer Rotor Positioning Sensor. This Sensor Assembly, also known as a hall sensor is a replacement Part and is a vital component in Specific LG, Kenmore washer Models. This part monitors the direction and speed of the spinning rotor. It then communicates this information to the electronic control board. By doing so, it aids in the precise operation of your washer. If your washer pumps but fails to spin or agitate, it may be indicative of a damaged sensor assembly.
Replaces Part Numbers
6501KW2001A, 6501KW2001D, PD00001726, EAP2497738, 6501KW2001C, EBR37560301, AP4457567, PS3529185.
Compatibility
This replacement rotor positioning sensor fits select LG and Kenmore front-load washers.
Example compatible models include (but are not limited to): LG WM2101HW, LG WM2487HRM, and Kenmore 796.40272900.
Always verify your washer’s model number before ordering. Contact our support team if you’re unsure.
✅ Key Features
-
🔄 Aftermarket Replacement – Designed to match OEM performance and accuracy
-
⚙️ Precise Motor Feedback – Helps control drum rotation and spin speed
-
💰 Cost-Effective Solution – High-quality alternative to OEM sensor assembly
-
🛠️ Easy Installation – Plug-and-play design with secure connector fit
-
🛡️ Fixes Common Issues – Resolves LE, UE, or spin-related error codes
📐 Product Specification
-
Part Number: 6501KW2001A
-
Component Type: Washer Rotor Position Sensor (Hall Sensor)
-
Material: High-durability circuit board and plastic housing
-
Mounting: Direct-fit replacement on motor stator assembly
-
Operating Conditions: Designed for high-humidity washer environments
-
Compliance: Built to OEM-equivalent quality standards (not OEM)
🛠️ Installation Notes
Tools Needed: 10mm socket wrench, Phillips screwdriver
⚠️ Safety First: Always unplug the washer before performing any repairs to prevent electrical shock.
Steps:
-
Disconnect power and remove the rear access panel.
-
Remove the rotor bolt and pull off the rotor assembly.
-
Locate and disconnect the wiring harness from the old sensor.
-
Remove the old 6501KW2001A sensor and install the new XPARTCO replacement.
-
Reconnect wiring, reinstall the rotor, and secure the rear panel.
-
Restore power and run a spin test to verify repair.
⏱️ Time Required: 20–25 minutes
📦 Shop With Confidence
Fix washer spin and motor issues — Add to Cart Now for a reliable, budget-friendly repair!
