Description
XPARTCO W11168740 Washer Water Valve (Cold Side) – Compatible with Whirlpool, Maytag, Amana, Kenmore, and Crosley Washers
Product Description
Restore proper cold-water filling to your washer with the XPARTCO W11168740 Washer Water Valve (Cold Side). This Water Inlet Valve is a replacement part for specific Kenmore, Maytag, Whirlpool washing machine models. It controls the flow of water into the washer tub at designated stages in the washing process. Water enters through the valve inlet and is distributed to internal components like the detergent dispenser, water pipes, and sump hoses. Common causes of a bad valve can include mineral scale buildup inhibiting proper flow regulation over time, or cracks and leaks from wear and tear on rubber gaskets and seals.
Replaces Part Numbers
W11168740, WPW10240949, W10240949, W10921514, 33390069, PD00038781, EAP12348073, AP6285450, PS12348073.
Compatibility
This replacement cold-side water valve fits select Whirlpool, Maytag, Amana, Kenmore, Crosley, and Estate washers.
Example compatible models include (but are not limited to):
Whirlpool WTW5000DW1, Maytag MVWC465HW2, Amana NTW4516FW3, Kenmore 110.25132411.
Always verify your washer’s model number before ordering.
Contact our support team if you’re unsure.
✅ Key Features
-
🔄 Aftermarket Replacement – Engineered to match OEM water flow and pressure performance
-
❄️ Cold-Water Control – Regulates cold-water intake for proper wash temperatures
-
💰 Budget-Friendly Option – Reliable performance at a lower cost than OEM valves
-
🛠️ Durable Solenoid Design – Ensures strong, consistent water flow
-
🛡️ Fixes Common Issues – Solves slow filling, no cold-water fill, temperature errors, or cycle interruptions
📐 Product Specification
-
Part Number: W11168740
-
Component Type: Washer Water Inlet Valve (Cold Side)
-
Material: Reinforced plastic body with metal solenoid
-
Ports: Single cold-water inlet
-
Mounting: Direct-fit installation on rear washer panel
-
Compliance: Built to OEM-equivalent quality standards (not OEM)
🛠️ Installation Notes
Tools Needed: Phillips screwdriver, pliers, towel or bucket
⚠️ Safety First: Unplug the washer and turn off water supply before installation.
Steps:
-
Disconnect power and shut off water to the washer.
-
Remove the rear access panel to expose the inlet valve.
-
Disconnect the cold-water hose and electrical connector.
-
Remove the mounting screws and take out the old valve.
-
Install the new XPARTCO W11168740 valve and reconnect wiring and hose.
-
Turn water back on, restore power, and test for leaks and proper filling.
⏱️ Time Required: 10–20 minutes
📦 Shop With Confidence
Restore dependable cold-water filling — Add to Cart Now for a reliable, cost-effective repair!
