How to replace Samsung dryer belt
, 4 min reading time
Is your Samsung dryer running but the drum won’t spin? A worn or broken drive belt is a common culprit — and replacing it is easier than you might think. This step-by-step guide walks you through how to replace a Samsung dryer belt with basic tools and a new belt from Parts-O-Matic.com — with Fast and Free U.S. shipping on every order.
How to Replace a Samsung Dryer Belt DIY Step-by-Step Guide
If your Samsung dryer is running but the drum won’t spin, chances are the drive belt has snapped or slipped off. Don’t worry — you can replace a Samsung dryer belt at home with a few tools, a bit of time, and a new belt from Parts-O-Matic.com — where we ship Fast and Free across the U.S..
⚠️ Common Signs Your Samsung Dryer Belt Is Broken
-
Dryer powers on, but drum doesn’t turn
-
You hear a humming motor, but no movement
-
You smell a burning rubber odor
-
Visible belt damage or no belt tension
🧰 Tools You’ll Need
-
New Samsung dryer belt
👉 Shop Samsung Dryer Belts » -
Phillips screwdriver
-
Flathead screwdriver or putty knife
-
1/4" nut driver or socket wrench
-
Towel or blanket to lay the dryer on
🛠️ Step-by-Step: How to Replace a Samsung Dryer Belt
🔌 SAFETY FIRST: Unplug your dryer and disconnect the gas (if applicable) before starting.
1. Remove the Top Panel
-
Remove the two screws at the back corners of the top panel.
-
Slide the panel back and lift it off.
2. Remove the Control Panel
-
Disconnect any wire harnesses (take a picture for reference).
-
Remove screws securing the panel and lift it away.
3. Remove the Front Panel
-
Open the door and remove screws around the door frame.
-
Carefully lift and disconnect the door switch wiring.
-
Set the panel aside.
4. Remove the Drum
-
Remove the belt (if it’s still intact) from the motor shaft and idler pulley.
-
Lift the drum straight out.
5. Install the New Belt
-
Wrap the new belt around the drum (grooved side inward).
-
Carefully place the drum back in position.
-
Route the belt under the idler pulley and over the motor shaft (look for a routing diagram inside the panel or online).
👉 Need a visual? Many Samsung dryer models follow the same routing as shown in this following picture.
6. Reassemble the Dryer
-
Replace the front panel and reconnect door switch wires.
-
Reattach the control panel and reconnect any wire harnesses.
-
Slide the top panel back into place and secure with screws.
✅ Test Your Dryer
-
Plug it back in and run a short cycle.
-
If the drum spins smoothly and there’s no noise, you’re good to go!
🛒 Need the Right Samsung Dryer Belt?
At Parts-O-Matic.com, we carry OEM-quality belts that fit Samsung dryer models including DV42, DV45, DV48, DV50, and more — all with Fast and Free U.S. shipping.
👉 Browse Samsung Dryer Belts »
🧠 Pro Tips
-
Consider replacing the idler pulley and drum rollers while you're in there.
👉 Shop Samsung Dryer Repair Kits » -
Clean lint from inside the cabinet and blower housing for better airflow and efficiency.
